Hi Greg,
I submitted a ticket and attached the zipped log.
Following the log after the event: CProject::LoadProject() there is a point where the current ASIO driver is removed. Later on in the log I see this:
10:50:56 [295 mils] : COutputTrack::Load() - Could not find original output device ASIO mode 4 for driver:hdspfire
10:50:56 [295 mils] : Output Bus 0 cannot be assigned to the correct output device because the device does not exist.
This does not happen in MC 9 470 doing the same steps I outlined previously.
I submitted a ticket and attached the zipped log.
Following the log after the event: CProject::LoadProject() there is a point where the current ASIO driver is removed. Later on in the log I see this:
10:50:56 [295 mils] : COutputTrack::Load() - Could not find original output device ASIO mode 4 for driver:hdspfire
10:50:56 [295 mils] : Output Bus 0 cannot be assigned to the correct output device because the device does not exist.
This does not happen in MC 9 470 doing the same steps I outlined previously.
Statistics: Posted by cactus-head — Thu Jun 13, 2024 11:42 am