Hi,
This might have been asked, but I can´t find an answer:
When opening an automation lane for a hardware midi track (in my case a Roland SH-201), there´s a greyed label "No automatable parameters".
Is there a way to map the hardware implementation chart to this menu? The result would be the same as in VST automation with parameters selectable in the menu. (I guess there must be a translation file/interface that controls this?)
Or maybe even more generic: just direct access to all 127 MIDI CC "channels" in this menu, rather than the "No automatable..." message? Since this is a MIDI standard it would be easy to replace the "No automatable..." message with the generic channels.
Thx, Fredrik
Image may be NSFW.
Clik here to view.
This might have been asked, but I can´t find an answer:
When opening an automation lane for a hardware midi track (in my case a Roland SH-201), there´s a greyed label "No automatable parameters".
Is there a way to map the hardware implementation chart to this menu? The result would be the same as in VST automation with parameters selectable in the menu. (I guess there must be a translation file/interface that controls this?)
Or maybe even more generic: just direct access to all 127 MIDI CC "channels" in this menu, rather than the "No automatable..." message? Since this is a MIDI standard it would be easy to replace the "No automatable..." message with the generic channels.
Thx, Fredrik
Image may be NSFW.
Clik here to view.
- Image may be NSFW.
Clik here to view.
Statistics: Posted by FREN — Sat Jun 15, 2024 2:56 pm
