Mixcraft • Re: Clip muting in take mode doesn't work properly in build 634

...and of course double-check that you're not in overdub mode. I can't get it to happen, either.

Sorry for the delay, I didn't have time to test. I checked it again in takes mode and it works incorrectly under certain conditions as I sayed.

If the previous clip starts earlier and ends later than the recording clip, then it won't work properly. Then what I described happens. The old clip will be muted during recording and then reactivated. I attached some screenshots with the result after recording.

ok when starting point is before the existing clip:
ok when end point is after the existing clip:
also ok when start and end point is befor and after the existing clip:


issue when start and end point is within the existing clip:

Since I'm using the takes mode here, I'd say that's wrong. But as I said, it works properly during recording. Only after recording the old clip is reactivated. If I want this result, then I would choose overdub

Patrick

Statistics: Posted by ppayne — Sun Mar 30, 2025 2:37 am

---